Other than a battery backup in case of power failure and a high water alarm in case of pump/switch failure, is there any way to make these systems safer? Thanks. This thing seems like an accident waiting to happen. I have had to go into the sewer ejection system more times than I can count to adjust, fix, replace one thing or another and the system is only 11 years old. While doing this job I examined the check valve because things didn't sound right (what does it mean when you know there might be a problem with your sewer ejection system because it doesn't "sound" right?) and discovered that the flap had been torn off and was just bouncing around within the valve. Once I removed the crud it seemed to work okay, although I will have to do more testing. There was "crud" on the float and, while the float did rise with the water level, it would not trigger the pump. The reason for my question is because I have had to remove the sealed cover, and go back in to correct an issue with the float not triggering the pump.again. These systems are essential in pumping sewage and other wastewater from a building’s plumbing system to the main sewer line or septic tank. I am now worried that the flap is unable to take the force of the water being discharged. Sewage ejector pump systems are commonly found in properties that are situated lower than the street level, such as basements or buildings located in low-lying areas. This pump features a 20/40-PSI pressure switch for reliable water pressure. The one that recently failed was from Lowes and cost about $60? It was installed vertically on the ejection pipe by the original plumber. Draw water from your well, lake, or stream with this Zoeller 1 HP pro convertible jet pump with ejector. Flows to : 960 gpm Heads to : 126 ft Discharge : 4 HP : 0.75 15. Flows to: 445 GPM Heads to: 96 TDH Discharge: 2-3 HP. Are these things prone to failing, or can I purchase a better one. Capable of handling between 2-3 inch spherical solids which help prevent clogging. The circular flap was torn off from the rubber "hinge" on the inside of the check valve. Recently the pump would not start because the float ball for the pump was caked with scum and it would not rise to the correct "angle" to trigger the pump.Īlso the check valve has failed and it was less than 2 years old. The sewage pit gets gummed up with, what I am assuming, is soap scum from the laundry and shower. The bathroom is not used for solid waste (no #2), but is used for liquid waste (yes #1). Is there a way to prevent the build-up of soap scum for a sewage ejector pit? Currently the sewage ejector system services the laundry room and a bathroom located in the basement.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |